This
is the Hasegawa Fw 190 A-5 in
1:32
scale. The model was built
basically straight from the box apart from a couple of enhancements. I
used the MDC instrument decals and was very impressed. I couldn’t
justify the money on a new cockpit when not much of the office is visible but
the decals do add that edge over dry brushing. The other addition was the etched
harness again from MDC. This is the first time I have used this company's
products and I am very impressed.
Click on
images below to see larger images
|
|
|
|
I
didn’t add anything to the wheel wells, you should really shallow the dimples
on the roof as they are too cylindrical but as my models just sit on the shelf I
couldn’t be bothered, no ones going to see up there!
The basic construction took less than a week, pretty good for a
1:32
scale kit. One near
disaster I had was I built the cowling and painted it before adding the engine,
AAHHHH! The engine does not fit in behind, you have to add it during the
construction of the cowling, much cutting, scraping and swearing later I managed
it but I nearly had to take the cowling apart again!
Once
the model was primed and pre shaded I painted the RLM 76 using Xtracrylics
from Hannant’s. The rest of the camouflage
was mixed up Tamiya colours from Modeldad’s list
and sprayed free hand while the yellow cowling was a Tamiya yellow mixed with
their gloss varnish. A quick buff with a soft rag and it was ready for the
decals. The black portion on the
fuselage sides were masked and sprayed as were the wing crosses. I usually
paint all the markings on Luftwaffe aircraft but I had run out of Eduard masks.
Click on
images below to see larger images
|
|
|
|
The
decals were from EagleCals and were absolutely first
rate. I was a bit nervous of the checkered nose, but they went on lovely.
After a quick wash, the model was Flat coated with Xtracrylics
matt varnish.
I did light weathering on this model, a bit of a departure for me as I
usually like really beat up looking models. The paint chips were done using a
silver artists pencil and I post shaded the model using the technique from the
inspirational Chris Wauchop (10% Tamiya black/red
brown, 90% thinner).
The
final things were to add on all the fiddly bits and she was done.
Jamie
Click on
images below to see larger images
|
|
|
|