I've always
loved the He 111, so when it came out in my scale (1/32) I kinda had to
have it - and for the price I reckon Revell have done a pretty decent job
with this kit. Would I do things different
were I to build it again? Sure, but I'll talk about the things I would do
over and leave it to you as to whether this effort is up to scratch.
First thing is
to add extra surface detail. The control surfaces have some nice detail in
them but the larger surface areas are almost devoid of anything other than
panel lines. And there's a LOT of surface area; it takes ages -but I
reckon its worth the hours of scratching and drilling. Instead of
drilling, (and especially on large flat areas) I find it quicker and just
as effective to use a pricking device to add rivets. I use a corn fork
from the kitchen drawer........seriously. I still drill on curved areas or
where the plastic is thinnest, but the corn fork fits in the hand so well
and its easy to control the amount of pressure placed on the plastic.
Whilst doing
the detail, I preserve my sanity by constructing some sub assemblies like
the cockpit - and I reckon the Eduard interior and seat belt sets are a
bit of a must. The wood grain on the navigators 'rest' bed was done by
spraying a dark brown and letting it dry properly, then spraying a lighter
colour and then just as that coat is still tacky, draw in the grain effect
with a sharp pointy object.....like a corn fork (so versatile). Cut out
the doors on the cockpit bulkhead so you can see the walkway down the
fuselage and the bomb racks (Not entirely convinced that the Eduard Bomb
Bay kit is as necessary as the others, but hey, if you want
to..........pretty pricey though for what you see). Last thing to say
about the cockpit is the 'glass'; its really good and shows off quite a
bit of the interior with a minimum of distortion. Do your self a BIG
favour and get the Eduard mask set.
Click on
images below to see larger images
|
|
Major
construction was surprisingly stress free. With other Revell kits, I've
become accustomed to buying 6 tubes of putty and hundreds of sheets of
sand paper, but with this kit Revell seems to have turned a corner.
Everything fit sweetly- even the the join on the underside where the wings
attach to the fuselage. Not one squeeze of filler was used- just a run of
C/A after gluing and a light sand.......Nice
The finish is
something I ummm and arrr about......I wonder if next time I might make
the contrast on the camo a little starker for effect, but on the other
hand, a lot of photos make it hard to tell the extent of such
contrast......Hmmmmmm, maybe lighten up the green with a bit of yellow
next time. Anyways, the finish was pre-shaded, then painted then pastel
dusted along the lines to give the model some extra depth. The guns were
replaced with Master metal barrels. The aerial line is stretched sprue.
All in all I reckon
this one turned out OK, but - and like I said - there's a few things I'd do
differently.........Next time.......
Mike
Pattison
Click on
images below to see larger images
|
|
|